Outboard motor recommendation. And long or short shaft ?

Started by Pfmiller, November 06, 2026, 09:01:21 PM

Previous topic - Next topic

Pfmiller

Looking to add an outboard to my Viper. Looking for recommendations make and long or short shaft. Also, dyi bracket or purchase factory ready bracket. Thanks. Pat Miller #221

Will Nye

#1
I don't have an out board the Viper that I sail on. I do have one for my Beneteau First 24 SE though. It is a Epropulsion 3 hp. That boat weighs 2,000 pounds and it will push it at @ 5 mph for about an hour in flat conditions. I have a long shaft but for a Viper I would go short shaft.

Pfmiller

Thanks for the information. I think short shaft is the way to go and past forum topics reference the Suzuki as the go to recommended. Now I have to track down a bracket. Unfortunately, PHRF requires an outboard for our region.

Todd Cowen

I have the Torqeedo short shaft which I mostly love.  really nice not to deal with fuel and run quietly.  It is a tad delicate but I am 10 years in and still going strong.  Part of the plastic tiller brok but not essential.  I have replaced one shear pin and one connector but parts are easy to find.

Peter Beardsley

Quote from: Pfmiller on November 08, 2026, 04:36:02 PMThanks for the information. I think short shaft is the way to go and past forum topics reference the Suzuki as the go to recommended. Now I have to track down a bracket. Unfortunately, PHRF requires an outboard for our region.
Agree with this recommendation - not sure if it was my prior guidance or not.  If you want to find a bracket, you can try calling Spinnaker Sailing in SF - they may have some extras in inventory.  If not, the new builder (SERO) is working on supplying misc. parts and can likely figure this out. 
Viper 640 East Coast Regional VP / Class Governor
Viper 333 "Glory Days"
Formerly Viper 269 "Great Scott!", Viper 222 "Ghost Panda" and Viper 161 "Vicious Panda"